Windows 2012 2-node failover cluster for Hyper-V. 2 LANs in place, one for iSCSI communication. In failover cluster manager, when viewing the summary page cluster core resources, I have my cluster name listed, with two IP addresses under it, 192.168.2.x for LAN, and 10.168.2.x for iSCSI. The second IP is in a "Failed" status.
In the Networks section, I have two cluster networks, the LAN network is enabled for cluster use, and the iSCSI network is disabled for cluster use. Here, both networks show as UP. In the properties of network 2, "Do not allow cluster network communication" is selected. The iSCSI network contains two NICS, each with an IP on the iSCSI subnet. MPIO is handeled by the initiator, with Dell's HIT kit layered on top (EqualLogic SAN).
Only problem is, when selecting Move Cluster Resources -> Best Possible Node, I get error 1223, "Cluster IP address resource 'Cluster IP Address 10.168.2.58' cannot be brought online because the cluster network 'Cluster Network 2' is not configured to allow client access. Please use the Failover Cluster Manager snap-in to check the configured properties of the cluster network."
No movement of cluster resources occur.
Does this indicate a problem, or is this typical of my setup?