I am receiving the following message when performing the validation or the create cluster
Occasionally this will happen on the other node as well, if I decide to start the wizard from the opposite node.
Futhermore, what is interesting about this is that I had setup a similar cluster that had the same issue but it went away after verifying that nothing was using the C: drive. Also rebooting but for some reason I cannot find any further information on this topic.
Background
Two nodes - Quorum defined 500 MB - it can be seen on both nodes. Apparently it does not like the disk 0 or C: drive?
Validate that a disk can fail over successfully with data intact.
Getting partition table for cluster disk 0 from node servername
Arbitrating for cluster disk 0 from node servername
Bringing online cluster disk 0 on node servername
Writing file data on cluster disk 0 partition 2
Taking offline cluster disk 0 on node servername
Releasing cluster disk 0 from node servername
Arbitrating for cluster disk 0 from node servername
Bringing online cluster disk 0 on node servername
Validating file data on cluster disk 0 partition 2
Removing temporary file data on cluster disk 0 partition 2
Taking offline cluster disk 0 on node servername
Releasing cluster disk 0 from node servername
Failed to release cluster disk 0 from node (servername,) failure reason: The requested resource is in use.
Failed to release cluster disk 0 from node (servername), failure reason: The requested resource is in use.
Any ideas?