Hyper-V Replica Issue

Hi Everyone,

I got one issue with Hyper-V Replica:

From a single-host I am replicating VMs to a Cluster. So far, so good.
After adding more Nodes to the Cluster, these can't receive the replication. One example:

Trying to enable the replication from single-host, I get an error that the replication can't be enabled. Clicking ok and trying again and again, it will go through the cluster nodes until it finds one that is properly configured.

Network access has been checked, local firewalls as well. Any idea regarding this behavior?

Thanks,
Jens

jensit.wordpress.com