Hi There,
When i configure Failover cluster, it should display all the available disks in “Disks” under “storage”. But in our case it is not showing any Disks. When I ran “validate Cluster” Wizard, I noticed below error.
“If the disk that you want to add does not appear at all in Disk Management (on any node), there might be an issue with the storage configuration that is preventing the operating system from recognizing or mounting the disk. Note that disks currently in use by the cluster will appear in Disk Management on one node only (the node that is the current owner of that disk). If the disk that you want to add appears in Disk Management but does not appear after you click Add a disk, confirm that the disk is configured as a basic disk, not a dynamic disk. Only basic disks can be used in a failover cluster.”
Thanks and regards
Venkat